FlexHub Forum

FlexHub General => General discussion => Topic started by: sergius_s on July 27, 2013, 06:27:12

Title: Transfer of FlexHub with Linux on Windows
Post by: sergius_s on July 27, 2013, 06:27:12

From Windows to Linux FlexHub is transferred without problems keeping all settings and accounts.
But when you transfer hub with Linux on Windows there is one detail.
When all of the folders and files already transferred to Windows, before running FlexHub.exe in the "lib" folder all files with the extension *.so must be removed.
Otherwise an error will occur "file not suitable for running on Windows or contains an error" and "ERROR: error loading module 'wx' from file '. / Lib / wx.so': % 1 is not an application Win32" and hub will not start.

Title: Re: Transfer of FlexHub with Linux on Windows
Post by: en_dator on August 08, 2013, 11:36:10

Correct, the preferred method would be to get the archive from the forum for the intended target system (linux or windows) and the just copy the files in the settings folder over to the new system, and if any changes has been done to the FlexHub.lua then that should either be edited the same on the new system, or copied over as well.

/1d